We have our own SOP (Standard Operating Procedure) for Quality Control. This ensures all Merchandise that we ship meets our clients Standards.

INSPECTION

Pilot Run Inspection

Once the production starts (approximately 50-75 pieces completed), pre-production check is carried out. A minimum of three pieces per size / colour are selected and verified for measurements.

In-Line Inspection

During production in-line inspection is carried out. Inline inspection is carried out daily during the course of production for an order, to effectively control quality. Pieces are randomly selected and verified for quality parameters & SPI.

End-Line Inspection

After 70 % of the consignments are packed, End-Line inspectors conduct a pre final inspection. This is considered as a Mini Final Inspection. The audit will cover styling, measurements, quality of packing assortments, presentation and finishing.

Final Inspection

After completion of the consignment final inspection is carried out as per the MIL STD 105E & AQL – Normal Level II Standards. For measurement check, Measurement verification chart will be used during inspections.
AQL – Normal Level II, 2.5 for Major defects, 4.0 for Minor defects, NIL for Critical defects.
If a critical fault is found, merchandise will be subjected to 100% re-inspection. If the number of major & minor faults are above AQL 2.5, the merchandise will be subjected to a re-inspection. The factory will be advised to recheck goods fully and offer for re-inspection.